How to Remote Control 6 Water Motorcycles

Water motorcycle is a recreational vessel that the rider sits or stands on, rather than inside of, as in a boat. Most are designed for two or three people. Water motorcycles are small, fast and fairly easy to handle and use. Besides recreational function, they are preferred for non-recreational function in accidents to pick up flood survivors. Also, there are obvious hazards of collisions and mechanical breakdowns of water motorcycles. How to prevent from accidents in time?

Someone wants to remote control 6 water motorcycles from long distance. That is a idea that from the beach, he is able to control the switch of a user that is getting wild or getting to close to danger. If we discover danger in advance, we can stop the water motorcycle.

He uses six 12VDC direct power output receivers with the long distance remote to control his water motorcycles.

1_01 (17)

Wire 6 water motorcycles to 6 receivers respectively and press button on and off to turn on or shut down water motocycles.

When any of water motorcycles is getting wild or getting to close to danger, he can press any button to stop any of them to prevent from accidents. What’s more, it is the long range remote control which can help him control water motorcycles from long distance.

广告

6V Remote Controller for Doorbell

A man wants to install a single channel remote to control his doorbell within the range of 150m. The old 6V doorbell was broken and he doesn’t want to repair the wires of doorbell. Ordinary wireless doorbell cannot be used because it doesn’t reach the distance he really wants. He has an idea that a transmitter is connected to the doorbell button and relay in receiver is connected to doorbell. The only problem is the control range of remote need to reach about 150m.

doorbell 2

Answer:

We recommend the 6V one channel 2000m receiver(S1U-DC06-ANT2) and long range transmitter (CB-1). Working voltage range of receiver is 6V. With normally open and close terminal, the voltage of the device being controlled is AC110~240V or DC0~28V. So it can be applied in 6V doorbell. Usually, you don’t have to supply additional power to doorbell because it can get 6V power from powered receiver when you connect them to the 6V power supply together. And the most significant is that it has extended external antenna which makes its control range up to 2000m (6000ft).

1 (8)

According to his requirement, he can connect the button of the bell to the transmitter by two wires. Then connect the bell to the relay in the receiver.

circuit

Setting control mode Momentary: Connect Jumper-1.

When he presses the button of the bell, RF signal will be sent out from transmitter to receiver. The receiver receives to turn on the relay, then the doorbell rings. Release the button, the doorbell stops ringing.

View details: www.ourautomation.com/-p-582.html

Online shop: www.ourautomation.com